Fuel tank breather
-
- Oil Pump
- Posts: 280
- Joined: Thu Apr 20, 2017 4:36 am
- What model do you have?: 1976 bay window
- Location: Roodeport
- Has thanked: 51 times
- Been thanked: 7 times
Fuel tank breather
Hi ,the fuel tank breather,is it ok to let the fumes out the bottom or must i make a plan to the air cleaner as the single carb with a pancake filter has not got any fitting for it.It was a 2L but now a 1600 engine in.
What material can I use in the engine lid ,top lid in the bus as the fibre? that was in there is shot.
Thanks in advance.
What material can I use in the engine lid ,top lid in the bus as the fibre? that was in there is shot.
Thanks in advance.
- fig
- Bus Driver
- Posts: 12214
- Joined: Fri Jan 20, 2006 10:08 pm
- What model do you have?: Type 2
- Facebook: https://www.facebook.com/groups/258896479219/
- Location: Where life is cheap and death is free
- Has thanked: 287 times
- Been thanked: 321 times
- Contact:
Re: Fuel tank breather
Most urban smog is caused by unburned hyrdocarbons, including evaporated fuel. In most first world countries and on all more modern cars, the fuel tank vents through an activated carbon filter to prevent escaping into the atmosphere. I'm not entirely sure that venting the tank to the carb inlet is a good idea because it may be a fire hazard. AFAIK, on SA baywindow buses the fuel tank vents into the atmosphere somewhere up one of the rear corners.
fig
Kaapse Kombi Kult
"Whether you think you can or whether you think you can't, you're right." -- Henry Ford
Kaapse Kombi Kult
"Whether you think you can or whether you think you can't, you're right." -- Henry Ford
- Tony Z
- Donor
- Posts: 14994
- Joined: Wed Sep 14, 2005 8:33 am
- What model do you have?: 2.3L 69; 1302; P/Van
- Location: Klipheuwel (near Durbanville), Cape Town or working at sea
- Has thanked: 191 times
- Been thanked: 487 times
Re: Fuel tank breather
Yip, they vent to atmosphere but go through carbon filters first. You can see them in the engine intake ducting on the body above the engine.
ANGRRR
http://www.aircooledvwsa.co.za/viewtopi ... 23&t=14775
1302S
http://www.aircooledvwsa.co.za/viewtopi ... 23&t=33521
Panel Van
http://www.aircooledvwsa.co.za/viewtopic.php?p=288723
http://www.aircooledvwsa.co.za/viewtopi ... 23&t=14775
1302S
http://www.aircooledvwsa.co.za/viewtopi ... 23&t=33521
Panel Van
http://www.aircooledvwsa.co.za/viewtopic.php?p=288723
vader wrote: The Force is strong with you young Sith Lord Z!
- retrovan
- Donor
- Posts: 8709
- Joined: Mon Feb 07, 2011 8:51 pm
- What model do you have?: 52T1,68FB,72Bay,75FL
- Location: Eich! no, in Jefferys Bay
- Has thanked: 421 times
- Been thanked: 539 times
- Contact:
Re: Fuel tank breather
Me thinks he is mistaken with the oil breather that goes to the carb, I have a pancake paper filter on my fastback, and I fitted a pipe fitting into the base of the filter housing to connect the oil breather, but please do not run your fuel tank breather into the carb, it will turn your ride into a nice bomb.
Herman
Herman
1952 Split Beetle 1835cc
1968 Fastback 2Lt.type4
1972 Low Light Bay Panel Van 2Lt type 4
1975 Fleetline Panel Van 1914cc
2020 MeFusco Beetle Truck 2Lt type 4
1972 FT Hahn SP 1776 cc
1968 Fastback 2Lt.type4
1972 Low Light Bay Panel Van 2Lt type 4
1975 Fleetline Panel Van 1914cc
2020 MeFusco Beetle Truck 2Lt type 4
1972 FT Hahn SP 1776 cc
-
- Oil Pump
- Posts: 280
- Joined: Thu Apr 20, 2017 4:36 am
- What model do you have?: 1976 bay window
- Location: Roodeport
- Has thanked: 51 times
- Been thanked: 7 times
Re: Fuel tank breather
Hi Fig,Tony and Herman
Its the breather pipes that come from the tank that used to fit to the air cleaner on the 2l.They are the steel pipes with the 6mm rubber fuel hose that joins them.At the rear of the engine bay the two steel pipes are on the top of the engine bay.The steel pipes are from the tank around the sides
Its the breather pipes that come from the tank that used to fit to the air cleaner on the 2l.They are the steel pipes with the 6mm rubber fuel hose that joins them.At the rear of the engine bay the two steel pipes are on the top of the engine bay.The steel pipes are from the tank around the sides
- retrovan
- Donor
- Posts: 8709
- Joined: Mon Feb 07, 2011 8:51 pm
- What model do you have?: 52T1,68FB,72Bay,75FL
- Location: Eich! no, in Jefferys Bay
- Has thanked: 421 times
- Been thanked: 539 times
- Contact:
Re: Fuel tank breather
These are the fuel vent system, but do not join to the carb, but to each other.
The vent comes from two points on the fuel tank, cross over to the opposite side, go up the air vent area, come down and then join in the engine compartment roof near the inside of the number plate. It should be a rubber tube that slips over both pipe ends.
On my bus these joints, and there are 8 or 9 of them, and they all started leaking as they did not have clamps on them and the pipe got hard and loose.
My recommendation is that you take the motor out, remove the fire wall, and remove the tank and inspect ALL the rubber fittings, as they split and leak when you least expect it.
What ever you do do not connect it to the carb.
Herman
The vent comes from two points on the fuel tank, cross over to the opposite side, go up the air vent area, come down and then join in the engine compartment roof near the inside of the number plate. It should be a rubber tube that slips over both pipe ends.
On my bus these joints, and there are 8 or 9 of them, and they all started leaking as they did not have clamps on them and the pipe got hard and loose.
My recommendation is that you take the motor out, remove the fire wall, and remove the tank and inspect ALL the rubber fittings, as they split and leak when you least expect it.
What ever you do do not connect it to the carb.
Herman
1952 Split Beetle 1835cc
1968 Fastback 2Lt.type4
1972 Low Light Bay Panel Van 2Lt type 4
1975 Fleetline Panel Van 1914cc
2020 MeFusco Beetle Truck 2Lt type 4
1972 FT Hahn SP 1776 cc
1968 Fastback 2Lt.type4
1972 Low Light Bay Panel Van 2Lt type 4
1975 Fleetline Panel Van 1914cc
2020 MeFusco Beetle Truck 2Lt type 4
1972 FT Hahn SP 1776 cc
- Tony Z
- Donor
- Posts: 14994
- Joined: Wed Sep 14, 2005 8:33 am
- What model do you have?: 2.3L 69; 1302; P/Van
- Location: Klipheuwel (near Durbanville), Cape Town or working at sea
- Has thanked: 191 times
- Been thanked: 487 times
Re: Fuel tank breather
in stock format, they do actually run into the filter like Vintage Man has said. But that is after having passed through the carbon filters.
It doesnt have to go into the filter, but if it does, it is a bit better for the environment.
Beetles of the same era run the vent to atmosphere. I run my bus's vent to atmosphere.
I cant remember exactly where in the filter it goes, but I'd run it to the atmosphere side of the filter element to reduce the low vacuum on it and thus avoid pulling out of the tank. Plus, if you do suck out of the vent, the fuel wont drain out the bottom and you'll effectively run out of fuel until you can get air back into the tank
It doesnt have to go into the filter, but if it does, it is a bit better for the environment.
Beetles of the same era run the vent to atmosphere. I run my bus's vent to atmosphere.
I cant remember exactly where in the filter it goes, but I'd run it to the atmosphere side of the filter element to reduce the low vacuum on it and thus avoid pulling out of the tank. Plus, if you do suck out of the vent, the fuel wont drain out the bottom and you'll effectively run out of fuel until you can get air back into the tank
ANGRRR
http://www.aircooledvwsa.co.za/viewtopi ... 23&t=14775
1302S
http://www.aircooledvwsa.co.za/viewtopi ... 23&t=33521
Panel Van
http://www.aircooledvwsa.co.za/viewtopic.php?p=288723
http://www.aircooledvwsa.co.za/viewtopi ... 23&t=14775
1302S
http://www.aircooledvwsa.co.za/viewtopi ... 23&t=33521
Panel Van
http://www.aircooledvwsa.co.za/viewtopic.php?p=288723
vader wrote: The Force is strong with you young Sith Lord Z!
-
- Oil Pump
- Posts: 280
- Joined: Thu Apr 20, 2017 4:36 am
- What model do you have?: 1976 bay window
- Location: Roodeport
- Has thanked: 51 times
- Been thanked: 7 times
Re: Fuel tank breather
@ Retrovan
Firstly big thanks ,i have done all the new pipes and fuel tank.If you have at look at number 28 that is were i am ,what is that components that it joins to.
Firstly big thanks ,i have done all the new pipes and fuel tank.If you have at look at number 28 that is were i am ,what is that components that it joins to.
-
- Oil Pump
- Posts: 280
- Joined: Thu Apr 20, 2017 4:36 am
- What model do you have?: 1976 bay window
- Location: Roodeport
- Has thanked: 51 times
- Been thanked: 7 times
- retrovan
- Donor
- Posts: 8709
- Joined: Mon Feb 07, 2011 8:51 pm
- What model do you have?: 52T1,68FB,72Bay,75FL
- Location: Eich! no, in Jefferys Bay
- Has thanked: 421 times
- Been thanked: 539 times
- Contact:
Re: Fuel tank breather
I would vent it to the left side air intake vent, away from the battery , but just to atmosphere is fine.Vintage man wrote: ↑Wed Mar 28, 2018 3:18 pm @ Retrovan
Firstly big thanks ,i have done all the new pipes and fuel tank.If you have at look at number 28 that is were i am ,what is that components that it joins to.
Herman
1952 Split Beetle 1835cc
1968 Fastback 2Lt.type4
1972 Low Light Bay Panel Van 2Lt type 4
1975 Fleetline Panel Van 1914cc
2020 MeFusco Beetle Truck 2Lt type 4
1972 FT Hahn SP 1776 cc
1968 Fastback 2Lt.type4
1972 Low Light Bay Panel Van 2Lt type 4
1975 Fleetline Panel Van 1914cc
2020 MeFusco Beetle Truck 2Lt type 4
1972 FT Hahn SP 1776 cc
- WolfgangT2b
- Drip
- Posts: 7
- Joined: Thu Sep 22, 2011 4:55 pm
- What model do you have?: T2b-Camper
- Location: Munich/Germany
- Contact:
Re: Fuel tank breather
Hi Vintage Man,
if you have a 1600 engine it should look like this. I would try to connect the hose to the filter (probably construct a connector), because I had liquid petrol coming out of this hose (full tank in extreme heat). Not much petrol, but enough for a cigarette butt …
Wolfgang
if you have a 1600 engine it should look like this. I would try to connect the hose to the filter (probably construct a connector), because I had liquid petrol coming out of this hose (full tank in extreme heat). Not much petrol, but enough for a cigarette butt …
Wolfgang
You do not have the required permissions to view the files attached to this post.
-
- Oil Pump
- Posts: 280
- Joined: Thu Apr 20, 2017 4:36 am
- What model do you have?: 1976 bay window
- Location: Roodeport
- Has thanked: 51 times
- Been thanked: 7 times