Betty the Oval - Donovan D - ex-MINCE

[Donovan D]

Slowly want to start getting back into this.
I noticed recently that I have no internals for the door. If anyone has, please let me know.
Looking for all door parts

[retrovan]

.......I have no internals for the door. If anyone has, please let me know.
Looking for all door parts

Post a photo, I still have most of the oval door inner parts.

They should be the same, but want to make sure if they will fit.

You may even have split doors.........

Herman

[Donovan D]

.......I have no internals for the door. If anyone has, please let me know.
Looking for all door parts

Post a photo, I still have most of the oval door inner parts.

They should be the same, but want to make sure if they will fit.

You may even have split doors.........

Herman

I doubt they are split doors, will take some photos over the weekend.

[retrovan]

Just trying to be funny......

The Parts I have are 56, so they should be the same, but just want to make sure.

Will look this weekend, and post photos of what I have.

Still have 2 sets of door latches as well, but will post what I have.

Herman

[Donovan D]

These doors also need a lot of work
The one door has been welded on the inside. I do have the glass but no internals.

[retrovan]

OK... Great stuff.

Have original VW 1956 Oval internal door parts for you.

Have the following;-
Left and Right Window regulators
Left and Right window Glass
Left and Right chrome trim with outer scrapers attached (near New)
Left and Right Vent window with chrome frame & pin attached.
Rubber for above (not too good but usable).
Left and Right Chrome slide Chanel slot for between vent window and door Glass.
Left and Right door jam lock kick block (two Pairs)
Left and Right door handle spline holder and rods. (two pairs)
Left and Right door lock mechanism (two pairs)
Left and Right inner door glass slide to hold guide rubber.

Will take photo's of all tomorrow.

Have two sets of snow flake rear tail lights complete as well.

Herman

[Terry Phillips]

Herman if the snow flake lights are for sale I might be interested.I had a spare set but helped someone out and never got paid ? my own fault I suppose.
Thanks

[retrovan]

Right here you go Donovan









Herman

[retrovan]

Herman if the snow flake lights are for sale I might be interested.I had a spare set but helped someone out and never got paid ? my own fault I suppose.
Thanks

@Terry Phillips

Hi Terry, not sure if Donovan wants the 1st set of Snow Flakes, but I have this 2nd set as well,

Here is a Pic.





Lets see what Donovan has to say, then you can PM me an offer on the two sets.

Herman

[Donovan D]

...not sure if Donovan wants the 1st set of Snow Flakes, but I have this 2nd set as well,

Here is a Pic.
Lets see what Donovan has to say, then you can PM me an offer on the two sets.

Herman

I am definitely keen on the window bits and the first Snow flake set.
Please PM me a price.

[retrovan]

You have PM

Let me know which parts you want,

Do you need the popes nose ??

Herman

[Terry Phillips]

No problem Herman.
Thanks

[retrovan]

No problem Herman.
Thanks

2nd set of snow flakes are yours if you want them, PM me an offer

Herman

[Donovan D]

This has again been put on hold.
Really got stuck into the oval over December holidays, it lasted about a week.
Other priorities took over again. The front end of the kombi is also sagging which I need to look at.

I got a donor beetle shortly after getting the oval, and the poor donor has been standing outside for quite a while now.
Last weekend I decided to start cutting all the panels I might need for the oval before it faces another winter.
My father also made a tool to open the gutters, which works a treat. Will take a pic of the actual tool, its in one of the VW books and was used in the factory.
Couple of pics of the donor beetle getting the chop.

[retrovan]

Good going there D

just remember I still have a lot of Oval parts, as well as German window rubbers and mouldings.

Have to make list as memory is fad..........

Herman