Page 2 of 2
Re: Rotary into bug/bus
Posted: Fri Jun 26, 2009 3:42 pm
by Racer-X
What would the cost be to install a N/A carbed rotary motor into a D/C Bay window bus?
Re: Rotary into bug/bus
Posted: Fri Jun 26, 2009 3:52 pm
by Chris
Bugger wrote:dubster wrote:So i have seen,id like a acvw oneday but if i cant resist the speed bug i might pop in a rotory...can always go back...what is a ballpark figure for a rx turbo motor in a buggy?
R30K with the Microtech radiator etc
Re: Rotary into bug/bus
Posted: Sat Jun 27, 2009 6:30 pm
by Racer-X
Yes, i saw this.
But i mean a carburated motor into an already watercooled vehicle?
Re: Rotary into bug/bus
Posted: Sun Jun 28, 2009 10:47 am
by Bugger
Bugger wrote:Racer-X wrote:How about if u swap a rotary into a watercooled bus?
would it be slightly cheaper coz the waterworks are all there?
Yes then you just need to build a back cross member to hold the motor and tranny in place
Now it is not easy to always predict a costing
Reason why your perfect install is not my or the next guys perfect install
I am busy with a Rotary that was already in a bug
I HAVE Removed all the wiring, Brackets and closed all 5000 holes that was drilled with Resin
Will start a thread About this one and the Rotary Puma getting Born
So to sum things up shortly
Radiaror system +- R5000
Microtech +-R9800
Basic complete install around +_ R30K
Now with out the Radiator and EFI you could do it for around R15000
But now you need a more Complex exhaust system R1500
You need to buy a N/A Intake manifold and Carb Not laying arround either R2500
If you are a hands on Guy alot of the Fabrication and Boermaak `n plan things you can Save huge amounts of money
When I do a conversion I either do it and charge for the Extra hours that I spend on the Car
or I rather Only supply all the bits and Pieces that the guy need for the conversion as not all has the R30k + to fork out at one time for a complete conversion
Re: Rotary into bug/bus
Posted: Sun Jan 30, 2011 12:09 pm
by Croaky
Hi guys -
I am in the very early stages of doing a rotary conversion on a beetle (I bought a '71 in running condition, body so so, pan great) and would like to know how much Pierre would charge if all the bits and pieces were supplied?
Thanks in advance!
Re: Rotary into bug/bus
Posted: Sun Jan 30, 2011 8:35 pm
by Bugger
Mail me at
buggerATtelkomsaDOTnet
Then I send you a list of everything you need and costings
Also just visit the Introduction thread in General discussions and say hi to all the other guys PLS
Re: Rotary into bug/bus
Posted: Sun Jan 30, 2011 9:27 pm
by Croaky
Hi Pierre, intro done and email sent.
I will try call you in the morning sometime to discuss my options.
thanks for the reply!