Page 2 of 2
Re: Project for the boys
Posted: Tue Jun 03, 2014 9:37 am
by Calvyn
So after much nagging by the boys, we checked the oil, put some fuel in the carb, checked the point gap, engaged the starter, and blow me down, the little 1200 started and ticked over smoothly. Gears seem to select fine, just need to sort out all the oil leak which seems to come from the crank oil seal on the engine.
Re: Project for the boys
Posted: Tue Jun 03, 2014 11:51 am
by Dazz
Thats a very nice feeling. Im sure all were smiling.
Re: Project for the boys
Posted: Thu Jun 05, 2014 9:24 pm
by Bugger
Yip as Fig said Very early box and I only have very limited parts avalable if you need repairs on these Boxes and I repair then With out any Waranty as there are no parts available
Best is to convert to later style transmission but now you will need to look for a 6V Case as your one will be 6v or get a very thin conversion bush when using a 12V casing with 6V Starter
If you need any Advice give me a Call 082 600 8663 Pierre Vdubtech
Re: Project for the boys
Posted: Fri Jun 06, 2014 2:45 pm
by Calvyn
Many thanks Pierre. I will give you a call early next week to chat.
Regards
Calvyn
Re: Project for the boys
Posted: Wed Jun 18, 2014 10:28 pm
by Bugger
Calvyn wrote:Many thanks Pierre. I will give you a call early next week to chat.
Regards
Calvyn
HI
When you ready
Re: Project for the boys
Posted: Thu Jun 19, 2014 2:11 pm
by Calvyn
Bugger wrote:Calvyn wrote:Many thanks Pierre. I will give you a call early next week to chat.
Regards
Calvyn
HI
When you ready
Hi Pierre,
have sent you a PM.
Regards