Page 1 of 1

ENGINE NOISE

Posted: Mon Apr 07, 2008 9:21 am
by virek
Morning ppl, hope you all had a great weekend :wink:

There is a very loud noise coming from the front pulley. Especially when she is idling or at low rpm's. Once I rev her up abit the noise is gone. Left the car at the mech this morning as it seems to be getting louder :( hope its nothing serious :(

The alternator belt also jumped off this morning :x

Any ideas what it could be?

Thanks

Re: ENGINE NOISE

Posted: Mon Apr 07, 2008 10:16 am
by brianj
could be a bearing in the alt running rough.... run it (not for long) without the belt and seee if the noise goes away. if it does , its the alt bearings.

Re: ENGINE NOISE

Posted: Mon Apr 07, 2008 10:37 am
by virek
brianj wrote:could be a bearing in the alt running rough.... run it (not for long) without the belt and seee if the noise goes away. if it does , its the alt bearings.
:oops: Sorry I forgot to mention I already did that.

Thanks brian, what else could it be? I checked the covers for loose nuts and bolts. The box is tight.

:idea:

Re: ENGINE NOISE

Posted: Mon Apr 07, 2008 10:47 am
by brianj
crank pulley grinding against the case.... this apparently is quite common.
if its coming from inside, its bad news....

Re: ENGINE NOISE

Posted: Mon Apr 07, 2008 11:25 am
by virek
brianj wrote:crank pulley grinding against the case.... this apparently is quite common.
if its coming from inside, its bad news....
Just called the mech for some feeddback, he dropped the motor and says the covers on the back were loose and rubbing against the engine :?

I find that hard to believe. If its coming from the inside, what is the solution?

Thanks

Re: ENGINE NOISE

Posted: Mon Apr 07, 2008 7:32 pm
by Tony Z
virek wrote: I find that hard to believe. If its coming from the inside, what is the solution?

Thanks
time to start again... rebuild

Re: ENGINE NOISE

Posted: Tue Apr 08, 2008 8:44 am
by virek
Got my baby back last night :D Sounding healthy again. Eventually was the engine covers :hangloose:

While the motor was out, had him fit a new engine rubber as well. Doesn't look to neat tho, have to finish it up myself.