Normally when this happens you will hear it progress, starts with light clicking to then knocking, it doesn't just seize at the drop of a coin, you missed the warning sounds. The loss of power is the last sign, this is when the rod / crank is melting the bearing.Vintage man wrote: Sun Oct 07, 2018 7:28 pm Today driving my 1600 tp bus it last all power then locked up, stripped the engine and found that only one big end ran a bearing. The bearing pushed out on the sidesWhy would the happen and could over heating have caused it. What would go first if it did over heat. Thanks in advance as it is really bugging me.Could overheating cause this without damaging the piston and barrels.
Big end failed
-
calooker
- Donor
- Posts: 4973
- Joined: Wed Sep 14, 2005 9:24 am
- What model do you have?: 77 SP
- Location: Johannesburg
- Has thanked: 5 times
- Been thanked: 98 times
- Contact:
Re: Big end failed
For what it's worth, ignorance has no limits ......
-
Vintage man
- Oil Pump
- Posts: 280
- Joined: Thu Apr 20, 2017 4:36 am
- What model do you have?: 1976 bay window
- Location: Roodeport
- Has thanked: 51 times
- Been thanked: 7 times
-
retrovan
- Donor
- Posts: 8710
- Joined: Mon Feb 07, 2011 8:51 pm
- What model do you have?: 52T1,68FB,72Bay,75FL
- Location: Eich! no, in Jefferys Bay
- Has thanked: 421 times
- Been thanked: 541 times
- Contact:
Re: Big end failed
If it was from overheating alone, the oil would have a burnt carbon smell and you would have damage to more then one bearing surface.
Herman
Herman
1952 Split Beetle 1835cc
1968 Fastback 2Lt.type4
1972 Low Light Bay Panel Van 2Lt type 4
1975 Fleetline Panel Van 1914cc
2020 MeFusco Beetle Truck 2Lt type 4
1972 FT Hahn SP 1776 cc
1968 Fastback 2Lt.type4
1972 Low Light Bay Panel Van 2Lt type 4
1975 Fleetline Panel Van 1914cc
2020 MeFusco Beetle Truck 2Lt type 4
1972 FT Hahn SP 1776 cc