Page 1 of 1
Baywindow Seatbelt upgrade
Posted: Fri Jan 10, 2020 3:00 pm
by Eugene
Hi all, I am looking to upgrade the Bay's seatbelts to inertia reel belts. I bought the Chinese version from local parts shop but lo and behold, they are too short! I cannot find any from Goldwagen. Any suggestions?
Re: Baywindow Seatbelt upgrade
Posted: Fri Jan 10, 2020 3:06 pm
by retrovan
Some guys buy Nissan Bakkie belts from the scrap yard, its supposed to fit.
I bought the same sets from Midas, but has extensions made for the side of seat buckles from my local cable guy.
Now I do not have to bend so low to clip my belt.
Herman
Re: Baywindow Seatbelt upgrade
Posted: Fri Jan 10, 2020 3:57 pm
by fig
I bought the Midas ones and they fit my baywindows perfectly. The stalks are too short to mount in a split bus though. The belts themselves are long enough.
Re: Baywindow Seatbelt upgrade
Posted: Fri Jan 10, 2020 4:07 pm
by retrovan
Forgot to tell you that they sell two models.
On the box you will see they have short stalks and they have long stalks.
You may have the short, then you just need to take them back and swap them.
Herman
Re: Baywindow Seatbelt upgrade
Posted: Sat Jan 11, 2020 10:52 am
by Thunder bunny
I also bought Midas ones and then got T3 stalks. They work perfectly.
Re: Baywindow Seatbelt upgrade
Posted: Sun Jan 12, 2020 8:31 am
by Eugene
Thanks guys.....I will try Midas. The ones I returned, had the long stalks but was easily 500mm too short.
Re: Baywindow Seatbelt upgrade
Posted: Mon Jan 13, 2020 3:37 pm
by Eugene
I went to Midas today and was surprised to find the very same ones sold at Good Hope....they are too short
Re: Baywindow Seatbelt upgrade
Posted: Mon Jan 13, 2020 3:41 pm
by sean
Re: Baywindow Seatbelt upgrade
Posted: Mon Jan 13, 2020 4:03 pm
by Eugene
That was nasty
with the seat belt fitted and no occupant to obstruct, the belt just reaches. They do come with a stalk as long as the box.
Re: Baywindow Seatbelt upgrade
Posted: Mon Jan 13, 2020 4:37 pm
by freddiebooysen
Eugene. Are those the ones that roll out of the little roller
So if there is no occupant you need to roll a bit out of the roller
A simple pull should do the trick not too hard though else it locks
Re: Baywindow Seatbelt upgrade
Posted: Mon Jan 13, 2020 5:58 pm
by retrovan
Have you got a bench seat or a through way with two seats ??
May be using the incorrect fixing points.
Mine is a walk through and I will take photos of the belts and fixing points is you want.
Herman
Re: Baywindow Seatbelt upgrade
Posted: Mon Jan 13, 2020 7:43 pm
by retrovan